Eno interactive boards integrate digital pens with whiteboard markers for a full multimedia experience. They use no wires or cords, are magnetic, dry erase, interactive, and virtually indestructible.
Unlike a SMART Board, Eno is not activated by touch. There is a control strip along the side, which you can select with the Eno pen, to change the Eno pen settings (as explained below).
Turn on & use Eno
-
Log into the podium computer and turn on the projector.
-
Remove the Eno pen cap, to turn it on.
-
Plug the bluetooth connection device into an available port on either the computer tower or the side of the monitor.
- Tap projection mode icon on the control strip.
Align the project image with the Eno board
Re-calibrate the projected image on the Eno board
If the cursor or writing on the board appears off by a few pixels, re-calibrate it.
-
Select the bottom button in the control strip twice to get the green calibration screen.
-
Select Disable.
-
Select the bottom button in the control strip twice to get the green calibration screen.
-
Adjust until the Eno pen and cursor are corrected.
-
Select Enable.
-
Verify that the projected image fits within the whiteboard frame.
- Tap the projection mode icon on the control strip once.
For more information or clarity on Eno, please contact Library and Technology Services (LTS)
- Library and Technology Services (LTS):
- Phone: 717-815-1559
- Email: LTShelp@ycp.edu
Still having trouble with Eno?
Submit a Ticket Here